Stave Production
The links in the table below point to
summary tables with the measurements defined in the documents
ATL-IP-QP-0012 and 0024.
| 4000-4019 | 4020-4039 | 4040-4059 | 4060-4079 | 4080-4099 |
| 4100-4119 | 4120-4139 |
Summary Table
Legenda:
For each stave the following
information are reported:
Column Meaning
1
Reduced stave number
2 Link to histograms
of torsion, planarity, sagitta [difference between model and measurements]
3
Link to histograms
of thermal distorsions between 20 and -7 C
4
Hightest planarity
value
5
Hightest torsion
angle
6
Hightest
sagitta
7
Weight
8
Link to thermal conductivity
measurements and plots
9
Highest temperature
difference between the stave surface and coolant
10
Highest temperature difference
on the stave surface.
Semantics:
Stave number: RED
at least one value
(planarity, torsion, sagitta, thermal distorsions, thermal conductivity)
above the
values specified
in ATL-IP-QP-0012 and 0024
PURPLE
faults or values outside the limits of ATL-IP-QP-0010 (staves sent
back to PLYFORM)
BLUE
not measurable into the cold box of Genoa
(eg: Al-pipe not centered)
YELLOW
non conforming TMT s
ORANGE
faults during the working in Genoa
[^]
stave assembled into the second mould
Measures
RED
this value above the value
specified in ATL-IP-QP-0012 and 0024
GREEN
this value above the value specified
in ATL-IP-QP-0012 for either crater or rubbish (glue,
adhesive tape..) on the stave surface
2nd Column
BACKGROUND if GREEN: delivery
date of this stavec and the follwing ones
For some staves more than one set of measurement
are reported.
The blue lines in the histograms are the acceptance values specified in ATL-IP-QP-0012.