Some hardware accessories may not yet reflect the NI-DAQmx terminal names shown here. If you are using a device in Traditional NI-DAQ (Legacy), refer to the Terminal Name Equivalents table for the Traditional NI-DAQ (Legacy) signal names.
![]() |
Caution If you plug the unmodified SCC-FT01 into any SCC socket other than single-stage AI (sockets J1 through J8) or AO (sockets J17 and J18), you can damage the E Series DAQ device. |
![]() |
||
Pin Number | AI Signal | AO Signal |
---|---|---|
1 |
E Series AI (X) |
E Series AO 0¹ |
2 |
E Series AI GND |
E Series AO GND |
3 |
— |
E Series AO 1¹ |
4 |
E Series AI (X+8) |
AO GND |
5 |
— |
— |
6 |
E Series AI GND |
PFI 5 |
7 |
— |
— |
8 |
E Series AI GND |
PFI 6 |
9 |
— |
+ 5 V |
10 |
— |
GND |
11 |
A GND |
A GND |
12 |
REF 5 V |
REF 5 V |
13 |
+ 15 V |
+ 15 V |
14 |
– 15 V |
– 15 V |
15 |
— |
— |
16 |
— |
— |
17 |
AI (X) – (from first stage) |
— |
18 |
AI (X+8) + (from first stage) |
— |
19 |
AI (X) + (from first stage) |
— |
20 |
AI (X+8) – (from first stage) |
— |
¹When the module is plugged into J17, when plugged into J18, the DAC output channels are reversed. |
![]() |
Note The factory configuration is the AI signal. |